Beuchat

Categories

• Masks (6)
• Snorkels (4)
• Open heel fins (1)
• Rash guards (1)
• Dive hoods (1)
• BCD's (1)
• Dive knives (3)
• Dive bag (10)
• Mesh bag (1)
• Drybag (1)
• Snorkel bag (3)
• Buoys (5)
• Parts (2)
• Bags & boxes (1)
• Freedive weight systems (2)
• Freedive masks (4)
• Fin blades & parts (1)
• Freedive fins (2)
• T-shirts (3)
• Miscellaneous (26)
• Show more

Brands

• Beuchat (78)

Size

Size

Whom will be using this set?

• Men (6)
• Women (6)

Size

Size

Most BCD’s are unisex, which means that both men and women can wear them. BCD’s for women are especially designed for women. These BCD’s are more narrow at the shoulders and shorter in length, to ensure that it is snug around the waist. Children’s BCD’s are available in smaller sizes.

• Men (2)
• Women (2)

CE cert for cold water

CE cert for cold water

Regsets with a CE cold water certificate have been tested in waters below 10 degrees. When diving in NL/BE this comes in handy. In summer, the water on the surface may be warmer than 10 degrees, however, when decending to greater depths, you’ll hit various thermoclines in which the water temperature may be less than 10 degrees.

• Yes (2)

Features

Features

Mesh bags are made out of mesh material, which allows the water to escape. Carry-on sized bags can be used as cabin luggage. Waterproof bags can be used to keep the water out, but also to keep your gear from leaking in, for instance, your car.

• Wheels (4)
• Telescope handle (3)
• Backpack (7)
• Mesh (1)
• Shoulder strap (4)
• Waterproof (2)
• Carry-on size (2)
• Show more

Integrated weight system

Integrated weight system

BCD’s which have an integrated weight system are already equipped with weight pockets. The weights themselves are never included. BCD’s which have an optional integrated weight system are not equipped with weight pockets. These can be purchased separately. BCD’s which have no pockets for the weight can only be used with a weight belt.

• Yes, integrated (1)

Length in CM

Length in CM

Length of entire knife in cm

1st stage connection

1st stage connection

The INT ( yoke) connection uses a clamp type to mount the regulator over the cylinder valve and is tightened into place by screwing the cap. This pushes the first stage into the sealing o-ring of the cylinder valve. With the DIN fitting the male part is screwed into the valve to securely capture the o-ring. We recommend the DIN connection, since this is a safer connection. This connection is mostly used for 300bar cylinders. However, the DIN300 bar connection also works with a 200bar tank valve

• YOKE (1)
• DIN300 bar (1)

Size

• Women (1)

Use

Use

You can fit a complete dive kit in a bag from 70L and upwards, depending on the thickness of your suit. In NL/BE you will probably need a 90L bag to fit all your gear in. In a bag which is 120L or larger, you will be able to fit 2 dive sets.

• Complete set (3)
• Suit (1)
• Reg set (1)
• Computer (1)
• Snorkeling (9)

BCD Type

BCD Type

A jacket BCD has air-chambers at the sides of the BCD. A wing BCD only has a bladder at the back. The pro’s of a jacket is that it will be easier to stay up-right at the surface. The pro of using a wing is that you will have more freedom of movement at the sides and front of the body.

• Jacket (2)

Material

Material

Most knives are made of steel. Titanium knives weigh less and are not prone to rust. Ceramic knives are the very sharp

• Steel (2)

1st stage HP port

1st stage HP port

A second high pressure port on a 1st stage is necesarry if you are contemplating to dive with a computer that is air integrated. The transmitter will be attached to the second high pressure port so that you will always have backup analogue SPG.

• 2 HP ports (1)

Type

• Short sleeved shirt (1)

SPG

SPG

These instruments (minimally) consist of an SPG

• Yes (1)

Type of fins

• Full footpocket (1)

Tip

• Sharp (3)

Volume

Volume

Volume of the bag

Inflator

Inflator

A standard inflator is situated on the top left shoulder strap, allowing you to inflate and deflate the inflator with two buttons at the end of the inflator. An i3 inflator is situated on the lower left side of the BCD. The advantage of the i3 inflator is that it is attached on to the vest and easier to find. Another advantage is that you don’t have to change your position in the water to deflate the BCD.

• standard (2)

1st stage LP port

• 4 lp-ports (1)

Material

Material

Rash guards are made of Lycra and protect you against the sun. Thermoguards are made of thinner neoprene and will protect you against the sun and will keep you warmer

• Lycra (1)

Depth gauge

Depth gauge

These instruments (minimally) consist of a depth guage

• Yes (1)

Weight

Light-weight

Light-weight

Light-weight BCD’s are usually very compact in size as well as that they weight less than standard BCD’s. They are also good travel BCD’s. Standard BCD’s can also be used when traveling. However, the conscious traveler always thinks about their bagage allowance.

• Yes (1)

Attachment

Attachment

When attaching the knife to your calf, you can use the strap. With a BCD you can either stow your knife in one of the pockets. Alternatively you can mount it to your pocket – this is brand specific sou se an Aqualung knife fora n Aqualung BCD. If you would like to mount the knife to the inflator, you could use the tool provided. Some knives can be attached to a weight belt or attached to the webbing, using the provided slits

• Leg (1)
• Hose (1)

Comes with

Comes with

These attachment options come with the knife. If there are more mounting possibilities then your can buy these tools seperately

• Straps (2)

1st stage air supply

1st stage air supply

When you dive with an unbalanced 1st stage, breathing may become a little harder as your cylinder is being depleted of air. A balanced 1st stage will give you an even resistance during your dive, as long as your cylinder contains more than 20 Bar. An overbalanced 1st stage will give you a little more pressure when at depth, which will make breathing at greater depth easier. You will be able to feel the difference from a depth of 20 to 25 meters.

• Overbalanced (1)

2nd stage venturi regulator

2nd stage venturi regulator

A venturi switch is a + and – switch on the 2nd stages that regulates airflow. When the switch is switched to the -, the 2nd stage will not free flow when entering the water. When it is switched to the +, breathing is easiest.

• Yes (2)

2nd stage air supply

2nd stage air supply

A balanced 2ns stage will make inhaling easier than an unbalanced 2nd stage. If you were to use an overbalanced 1st stage then you’ll always have to use a balanced 2nd stage.

• Balanced (2)

EN250A

EN250A

Regulator sets with an EN250A marking have been tested by breathing simultaniously through the primary 2nd stage and the octopus. This will increase the pressure that is put on the 1st stage and these regsets have passed that specific test. These sets can be used with an octopus up to a depth of 30 meters. Below 30 meters a separate air system with an extra 1st stage is advised.

• Yes (2)

Size vest

• XS (1)
• S (1)
• M (1)
• L (1)
• XL (1)

Colour

• White (4)
• Grey (2)
• Blue grey (1)
• Light blue (4)
• Navy blue (2)
• Blue (7)
• blue bs (1)
• Dark blue (3)
• Turquoise (1)
• Lime green (1)
• Green (1)
• Army green (1)
• Yellow (6)
• Orange (1)
• Red (7)
• Burgundy (2)
• Pink (4)
• Fuchsia (1)
• Purple (2)
• Black (7)
• Black bs (1)
• Mixed (1)
• Light pink (1)
• Red bs (1)
• Pink bs (2)
• wit bs (2)
• Show more

Fin size

• 32/33 (1)
• 34/35 (1)
• 36/37 (1)
• 38/39 (1)
• 39/40 (2)
• 40/41 (1)
• 41/42 (2)
• 42/43 (1)
• 43/44 (2)
• 44/45 (1)
• 45/46 (2)
• 46/47 (1)
• 47/48 (2)
• S (2)
• S/M (1)
• M/L (3)
• L/XL (1)
• XL (2)
• Show more

Size hood

• Man S (1)
• Man M (1)
• Man L (1)
• Man XL-XXXL (1)
• Lady S (1)
• Lady M (1)
• Lady L (1)
• Lady XL (1)
• Show more

Maat Beuchat

• XS (2)
• S (3)
• M (3)
• L (3)
• XL (3)
• XXL (1)