Xdeep Hydros Wing

De XDEEP Hydros Wing is een technische wing, verkrijgbaar in een 40 lbs en een 50 lbs maat en is speciaal ontworpen voor technische duiken met stage cilinders en advanced recreatief duiken met een dubbele cilincer set.

De Hydros 40 wing heeft een hefvermogen van 40 lbs / 18kg (Max 2x18L) en de Hydros 50 wing heeft een hefvermogen van 50 lbs / 22kg (Max 2x18L).

De Hydros is zo gemaakt dat exact het midden van het drijfvermogen overeenkomt met het midden van de fles.
Door deze opstelling zal het drijfvermogen nooit veranderen tijdens de duik. (met een volle tank of een met lege tank.)
Om makkelijker bij kranen te kunnen komen heeft XDEEP de "dead zone" aan de bovenkant van de wing sterk verminderd.
Slangen zijn goed te begeleiden door speciaal ontwerp.
De buitenkant van de wing is gemaakt van duurzaam Cordura® 1100 dTEX gemaakt in Duitsland.


Trim and Stability to meet the most critical eye
Learning how to hold good trim and a stable position in the water is often the hardest skill for a new technical diver. For an experienced technical diver they want their equipment to help, not be something they have to compensate for. The HYDROS was designed so that the buoyancy in the wing perfectly matches the centre of gravity of the gas in your twinset.

Irrespective of the inflation level of the wing, or the remaining cylinder pressure, the system trim will not change during the dive.

Valve Shutdowns – faster and safer
The last thing you want between you and your valves is a flap of wing that slows down your response to a problem. Shutdowns and valve management have been improved by reducing the volume of the wing in the valve area, and through the area where you want to route your hoses.

Its easier to configure a clean and tidy hose routing, leaving your valves clear and accessible.

Reduced drag but the same buoyancy
Smaller contour wings have less drag and a lower risk of entanglement. In classic twinset BCD designs if you reduce the contour of the wing, then you lose overall buoyancy. Not in the HYDROS.

By minimizing the dead zone in the HYDROS from the central part of the bladder, we have reduced the overall wing contour and kept all the buoyancy you need. A bit of lateral thinking!

Comfortable and high up at the surface
It is a challenge to design a wing that holds you in perfectly flat trim underwater, yet holds you upright and high at the surface. Most designs want to push your face back underwater. In the HYDROS the design ensures that the majority of the wing and therefore buoyancy is kept beneath the surface.

Even loaded with two full stages and gear for a deep technical dive, HYDROS will hold you high and comfortable out of the waves.