Artikelomschrijving Divevolk SeaLink Contact Type Underwater WiFi Signal Transmitter
The SeaLink Contact-type underwater Wi-Fi signal transmitter is a unique design that build up Wi-Fi connection between smartphone and camera underwater.
It allows users to operate the camera through smartphone, or to take the smartphone as an underwater monitor for the camera.
Frequency 2.4G/5G/5.8G
Signal Gain 6 dbi
Waterproof 80 Meters
Wire Length 30cm
Package Included
The SeaLinkTM contact-type underwater Wi-Fi signal transmitter
L shape bracket
I shape bracket
M6 screw x 4 pieces
1/4 screw x 1 piece
Gasket x3 pieces
Quick Start Guide
EVA packing case
Instruction for use
Please position the sensor within the screen area of camera housing in case the aluminum alloy camera housing isolates the Wi-Fi signal.
Do not over-bend the wire, otherwise it will be damaged or affect the waterproof performance.
The SeaLinkTM Contact-type Wi-Fi signal transmitter needs to be installed on the expansion clamp of the SeaTouch housing.
It might be slight delay of the image transmission when using the Wi-Fi connection, the transmission status will vary depending of the performance of different camera.
It is recommended to complete the pairing and connection of the smartphone and the camera on land before launching into the water.
In order to use this product better, please watch the operation video before further use.
Installation diagram
Use two M6 screws to fix the sensor on the expansion clamp of the SeaTouch housing
Position the sensor on the edge of The SeaTouch housing
Use a M6 screw to fix the other senor on the L shape bracket
Use a M6 screw to fix the L shape bracket on the I shape bracket
Use the 1/4 screw to fix the I shape bracket on the bottom of the camera housing
